PURSUIT OS 335 Owner's Manual download pdf (Page 65)

OS 335

COCKPIT SHOWER

A fresh water shower is located behind a small door in the cockpit. It is supplied hot and cold water by the

fresh water system and works much like the shower in the head.

L-LOUNGE

The L-shaped lounge passenger seat is located on the port

side of the bridge deck. A cooler is located behind the lounge

seat. The insulated cooler drains overboard. An aft facing

folding seat is located below the cooler door. A door below

the L-lounge provides access to storage.

STERN SEAT

A fold down seat is built into the rear of the cockpit. To use

the aft seat, grasp the lower edge of the seat and raise it until

it locks into position. To lower the seat, squeeze the two

release latches located on the seat support and lower the seat

to the stowed position.

HARD TOP

The hard top consists of a laminated fiberglass top mounted to a welded aluminum frame that is bolted to the

deck. It is designed to accommodate radio antennas, radar antennas and navigation lights. It could also be

equipped with optional outriggers and/or rod holders.

The hard top is not designed to support the additional weight of items like an instrument locker or a life raft.

Radar antennas must be mounted to the top between the front and rear legs. Do not mount any antennas or

equipment to the brow area. The hard top frame is not designed to support the weight of accessories in this

area and could be damaged. The starboard rear leg is the wire chase for lights and antennas mounted to the

top.

The warranty for the hard top will be void if the top is modified in any way or heavy accessories like life rafts

or electronics lockers are mounted to the top. Additionally, if items like radar antennas, spotlights and other

accessories are mounted in the wrong location, the warranty could be void. If you intend to add equipment

or make modifications to the hard top, you should contact Pursuit Customer Relations to make sure the

equipment you would like to add or the intended modification will not void the warranty on the top.

Because the aluminum frames vary slightly, the side curtains, front clear connector and drop curtain are custom

made to each boat at the factory. To install the curtains, attach the front clear connector into the zipper at the

front of the top and snap it to the top of the windshield frame beginning with the center snaps. The clear

connector will have to be stretched just enough to pull out the wrinkles to reach the snaps on the windshield.

Once the clear connector is completely installed, the side curtains can be put on. First, zip the top of the side

curtains and then zip the front connector. Snap the curtains to the windshield and the deck beginning with

the forward snaps on the windshield. The side curtains will have to be stretched slightly to pull out the wrinkles

and reach the snaps.

If you have an optional drop curtain, slide it into the slide track on the back of the hard top and attach it to

the rear of the side curtains. Snap the drop curtain to the deck and cockpit.

There is a hole drilled in one of the leg bases to prevent water from being trapped within the leg and provide

a wire chase for accessories. A small hole is drilled in the tubing at the base of the other legs, which are not

Stern Seat

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 135 136

Comments to this Manuals

No comments

PURSUIT OS 335 Owner's Manual Page 65

Comments to this Manuals

Related products and manuals for Toys & accessories PURSUIT OS 335