PURSUIT OS 335 Owner's Manual download pdf (Page 45)

OS 335

tor to be removed from the boat in its entirety should major service be required. If this hatch is removed, it

must be rebedded with an approved marine sealant to prevent leakage into the bilge area. Pursuit strongly

recommends that this hatch only be removed and reinstalled by your Pursuit dealer or qualified marine

technician.

FUEL INJECTED GENERATORS REQUIRE BLEEDING OF AIR FROM THE FUEL DELIV-

ERY SYSTEM PRIOR TO INITIAL START-UP. BLEEDING OF THE FUEL SYSTEM WILL

ALSO BE REQUIRED IF THE GENERATOR IS ALLOWED TO RUN OUT OF FUEL. CON-

TINUED ATTEMPTS TO START THE GENERATOR WITHOUT BLEEDING THE FUEL SYS-

TEM UNDER THESE CIRCUMSTANCES CAN LEAD TO ENGINE DAMAGE OR ERRATIC

OPERATION. THIS PROCEDURE MUST BE COMPLETED BY YOUR SERVICING DEALER.

GENERATOR PANEL

These switches control the starting, running, blower, AC power selector

and stopping of the generator. The procedures may vary depending on

the model and type of generator installed in your boat.

Generators charge the battery just enough to compensate for the DC

electrical current the engine requires to operate. Therefore, it is

important to activate the battery charger to maintain the house battery

whenever the generator is running.

GENERATOR ENGINES PRODUCE CARBON MONOX-

IDE WHICH IS A LETHAL, TOXIC GAS THAT IS

COLORLESS AND ODORLESS. IT IS A DANGEROUS GAS THAT WILL CAUSE DEATH

IN CERTAIN LEVELS. ONLY OPERATE THE GENERATOR IN WELL VENTILATED AR-

EAS AND NEVER OPERATE THE GENERATOR WHILE YOU ARE SLEEPING.

AC POWER SELECTOR SWITCH

The generator panel will be equipped with this switch if the optional AC generator has been installed in your

boat. Move the selector switch to the “SHORE” position when connected to dockside power. Move the selector

switch to the “OFF” position when disconnecting the dockside power or when no AC power is being supplied

or for starting the generator. Move the selector switch to the “GENERATOR” position when the generator

is being operated.

DO NOT ATTEMPT TO START THE GENERATOR WITH THE SELECTOR SWITCH IN

THE "GENERATOR" POSITION. WAIT UNTIL THE GENERATOR HAS WARMED UP BE-

FORE TRANSFERRING THE ELECTRICAL LOAD. ONCE THE GENERATOR HAS RUN FOR

3 OR 4 MINUTES, PLACE THE SWITCH IN THE GENERATOR POSITION.

4.7 Electrical System Maintenance

12-VOLT DC ELECTRICAL SYSTEM MAINTENANCE

At least once a year, spray all exposed electrical components behind the helm and in the plugs, with a protector.

Exterior light fixture bulbs should be removed and the metal contact areas coated with a non-water soluble

lubricant like petroleum jelly or silicone grease. The sockets should be sprayed with a protector. Care must

be taken not to get any oil or petroleum jelly on the glass portion of the bulbs as this will cause the bulb to

overheat and burn out.

NOTICE

Gasoline Generator Panel

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 135 136

Comments to this Manuals

No comments

PURSUIT OS 335 Owner's Manual Page 45

Comments to this Manuals

Related products and manuals for Toys & accessories PURSUIT OS 335