PURSUIT OS 335 Owner's Manual download pdf (Page 52)

OS 335

5.3 Air Conditioning Pump (Optional)

The air conditioner is self-contained and sea water cooled. An AC centrifugal raw water pump supplies sea

water that cools the condensing unit as it circulates through the system and is discharged overboard. The pump

is located below the waterline and is activated whenever AC current is available and the air conditioning system

is operating.

Sea water is supplied to the pump from a thru-hull fitting located in the hull near the pump. A sea strainer

between the pump and thru-hull fitting protects the system from contaminants that could damage the pump

or the air conditioning system. Make sure the sea water pump receives adequate sea water by periodically

cleaning the sea strainer basket.

The pump, the strainer and seacock are located in the aft bilge on the starboard side.

Please refer to the air conditioner owner's manual for more information on the operation and maintenance of

the air conditioner.

5.4 Livewell

Sea water is provided to the livewell by a 12-volt circulating pump. This pump is designed to carry a constant

flow of water to the livewell. The pump is activated by the livewell switch in the cockpit. An overflow built

into the livewell automatically controls the water level in the livewell. Always turn the pump off at the switch

panel when the livewell is not in use.

The livewell is also equipped with an aerator pump. This pump circulates the water in the livewell. Either

the livewell pump must be operating or the livewell full of water with the drain plug firmly secured for the

aerator pump to function.

The livewell pump is equipped with a sea strainer on the intake side of the pump located aft bilge port side.

This should be checked frequently and cleaned as necessary.

To fill the livewell, insert the plug into the drain fitting at the bottom of the livewell. Make sure the valve

at the intake thru-hull fitting is open and activate the livewell switch. When the water level reaches the

overflow, it will begin to circulate.

To drain the livewell, turn off the livewell pump and pull out the plug in the drain fitting at the bottom of

the livewell. When the livewell has completely drained, use the washdown hose to flush the livewell and drain

debris.

The livewell supply thru-hull valve should be closed whenever the livewell is not in use. This will prevent

water from entering the livewell while the boat is cruising.

DO NOT USE THE LIVEWELL AS A DRY STORAGE AREA WHEN IT IS NOT IN USE.

SEAWATER COULD ACCIDENTALLY BE DELIVERED TO THE LIVEWELL FROM THE

THRU-HULL FITTING AND DAMAGE EQUIPMENT STORED THERE.

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 135 136

No comments

PURSUIT OS 335 Owner's Manual Page 52