PURSUIT 2470 CENTER CONSOLE Owner's Manual download pdf (Page 58)

2470 CENTER CONSOLE

9.2 Marine Head System (Optional)

This system is provided as optional equipment. The flush water is

supplied by a thru-hull fitting and a raw water line. Before using,

open the inlet valve on the head and pump to wet the inside of the

bowl. After use, close the valve and pump to discharge the waste

to the holding tank or overboard.

Waste can be directed either into the holding tank or overboard,

when legal to do so. This is accomplished by an optional Y-valve

located in the stern bilge below the tackle locker.

In the overboard discharge position, the waste exits the

boat through a large thru-hull fitting located in the

stern bilge. The thru-hull fitting is equipped with a ball

valve. Always open this valve when the overboard

discharge is selected and close it when the holding tank

is selected.

In the holding tank position, the waste is pumped

directly into the holding tank where it remains until it

is pumped out by a waste dumping station or the

optional overboard discharge system.

IN MANY AREAS IT IS ILLEGAL TO FLUSH HEAD WASTE DIRECTLY OVER-

BOARD. VIOLATION OF THESE POLLUTION LAWS CAN RESULT IN FINES OR

IMPRISONMENT. ALWAYS KNOW THE LAW FOR THE AREAS IN WHICH

YOU BOAT. NEVER DUMP HEAD OR HOLDING TANK WASTE OVERBOARD

ILLEGALLY.

Holding Tank

The holding tank is located in the bilge area. When the tank is full it must either be pumped out

by an approved waste dumping station through the waste deck fitting or be pumped overboard

with the optional macerator discharge pump, when legal to do so. When the macerator discharge

pump is installed, the Y-valve will be used to select either the macerator discharge pump or the

waste deck fitting to evacuate the holding tank.

Y-Valve

Marine Head

9-2

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 121 122

No comments

PURSUIT 2470 CENTER CONSOLE Owner's Manual Page 58