PURSUIT 2470 CENTER CONSOLE Owner's Manual download pdf (Page 49)

2470 CENTER CONSOLE

7.6 Console Cooler Drain

The console cooler is drained by gravity. Water is channeled from the cooler to the cockpit sole

and then overboard through the scuppers. The cooler should be flushed out and cleaned after each

use.

7.7 Maintenance

It is essential that the following items be done periodically to maintain proper drainage of your

boat:

• Clean the cockpit drain rails with a hose to remove debris that can block water drainage.

• Operate the thru-hull valves once a month and service as required.

• Clean the T-top leg drain holes. This is especially important just before winter lay-up.

• Clean the bilge pump strainers of debris and check the bilge for foreign material that can cause

the automatic switches to malfunction.

• Frequently test the automatic bilge pump switch for proper operation. This is accomplished

by inserting a stiff wire or small rod through one of the slots in the float chamber of the pump

and lifting the float switch until the pump turns on. You can also use a hose to flood the bilge

until the water level is high enough to activate the pump.

• Flush all gravity drains with fresh water to keep them clean and free flowing.

• Clean and flush the fishboxes and coolers with soap and fresh water or a bilge cleaner after

each use to keep them clean and fresh.

ALL DRAINS AND PUMPS MUST BE PROPERLY WINTERIZED BEFORE WINTER

LAY-UP.

NEVER USE HARSH CHEMICAL DRAIN CLEANERS IN MARINE DRAIN SYSTEMS.

PERMANENT DAMAGE TO THE HOSES AND FITTINGS MAY RESULT.

7-3

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 121 122

No comments

PURSUIT 2470 CENTER CONSOLE Owner's Manual Page 49