PURSUIT 2470 CENTER CONSOLE Owner's Manual download pdf (Page 51)

2470 CENTER CONSOLE

Chapter 8:Chapter 8:

Chapter 8:

EXTERIOR EQUIPMENT

8.1 Deck

Rails and Deck Hardware

The rail system and hardware fittings have been selected and installed to perform specific

functions. Fenders or mooring lines should be secured to the cleats and not to rails or stanchions.

Mooring lines should be secured to the stern cleats. Be sure a clear lead exists when running dock

lines or anchor lines. A line inadvertently run around a stanchion or over the rail could cause

damage.

IMPORTANT: All fittings must be periodically inspected for loose fit, wear and damage.

Any problems should be corrected immediately.

PURSUIT BOATS ARE NOT EQUIPPED WITH HARDWARE DESIGNED FOR TOW-

ING PURPOSES. THE MOORING CLEATS ARE NOT TO BE USED FOR TOWING

ANOTHER VESSEL OR HAVING THIS BOAT TOWED.

Bow Pulpit and Roller (Optional)

The bow pulpit can be equipped with a roller assembly that allows

the anchor to be operated and stored at the pulpit. The anchor line

is stored in the rope locker and routed out the rope locker hatch,

through the roller and connected to the anchor chain. Always

make sure the anchor is properly secured when it is in the stored

position on the pulpit.

Anchor/Rope Locker

The anchor locker is in the bow of the boat and accessed through

a hatch in the deck. The anchor line is always stored in the locker.

The anchor can be mounted on the optional bow pulpit or stored

in the anchor locker. If the anchor is stored in the anchor locker

it must be properly secured to prevent it from bouncing in the

locker and causing damage to the hull or anchor locker.

The anchor locker is drained to the bilge by a drain in the floor of

the locker. It is very important to check the drain frequently to

make sure it is clean and free flowing.

Anchor/Rope Locker

Bow Pulpit and Roller

8-1

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 121 122

No comments

PURSUIT 2470 CENTER CONSOLE Owner's Manual Page 51