PURSUIT 2470 CENTER CONSOLE Owner's Manual download pdf (Page 42)

2470 CENTER CONSOLE

DO NOT ALLOW THE FRESHWATER PUMP TO RUN DRY. THIS CAN RESULT

IN DAMAGE TO THE PUMP.

5.3 Freshwater System Maintenance

Information supplied with water system components, by the equipment manufacturers, is

included with this manual. Refer to this information for additional operation and service data.

The following items should be done routinely to maintain your Freshwater System:

Periodically, remove the water tank vent and clean corrosion and salt buildup from the vent

screens. The screens will prevent insects and other foreign matter from contaminating the water

system. The vent should be replaced if the vent or screens are damaged or badly corroded. Vent

screens that are clogged will prevent the water tank from venting properly and make filling the

tank difficult.

Be sure the screens are secure and that the vent hose is properly routed and attached when the vent

is reinstalled or replaced. The vent hose must be looped above the vent, secured to the hull near

the vent and securely attached to the vent hose fitting with a hose clamp.

Remove the filter screens from the faucet spouts and eliminate any accumulation of debris. A

build up of debris can cause the pump to cycle excessively.

The freshwater system is equipped with a strainer located on the intake line near the pump. This

should be checked at least annually and cleaned as necessary.

Periodically spray the pumps and metal components with a metal protector.

Add a commercially available potable water conditioner to the water tank to keep it fresh.

THE BATTERIES MUST BE PROPERLY CHARGED. OPERATING THE FRESHWA-

TER PUMP FROM A BATTERY WITH A LOW CHARGE MAY LEAD TO A PUMP

FAILURE.

5-2

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 121 122

No comments

PURSUIT 2470 CENTER CONSOLE Owner's Manual Page 42