PURSUIT 2870 OFFSHORE Owner's Manual download pdf (Page 48)

2870 OFFSHORE

Check the electrolyte level in the batteries regularly and add distilled water as necessary. If the

batteries are frequently charged by the automatic battery charger, the electrolyte level will have to

be checked more often. The correct fluid level in the cells is usually approximately 1/4 to 1/2 inch

above the plates. If fluid is needed, fill to the proper level with distilled water. Do not over fill!

Please note that some batteries are sealed and cannot be filled.

Keep the battery tops clean and dry. Dirt and water can conduct electricity from one post to the

other causing the battery to discharge.

The battery posts should be kept free of corrosion. Remove the cables and clean the posts and cable

clamps with a battery post cleaner or sandpaper as required. Coating the battery posts and cable

clamps with petroleum jelly or silicone grease will protect them and reduce corrosion. Battery

cables, both hot and ground, must be replaced when they show signs of corrosion or fraying.

Deteriorated cables cause a considerable voltage loss when high currents are drawn, as for starting

the engine.

NEVER USE AN OPEN FLAME IN THE BATTERY STORAGE AREA. AVOID STRIKING

SPARKS NEAR THE BATTERY. A BATTERY CAN EXPLODE IF A FLAME OR SPARK IG-

NITES THE HYDROGEN GAS THE BATTERY EMITS WHILE BEING CHARGED.

110-Volt AC Electrical System Maintenance

Periodically inspect all wiring for nicks, chafing, brittleness, improper support, etc. Examine the

shore power cord closely for cracks in the insulation and corrosion in electrical connectors.

Spraying receptacles and electrical connections with an electrical contact cleaner or a metal and

electrical protector will reduce corrosion and improve electrical continuity.

Inspect all wiring for proper support, sound insulation, and tight terminals, paying particular

attention to portable appliance cords and plugs.

The entire 110-volt circuitry, especially the shore power cord, should be seasonally tested for

proper continuity by an experienced electrician. This will detect any shorts, open wires, or ground

faults. Ground fault interrupts should be tested periodically to insure proper operation by pressing

the test/reset buttons in the center of face plate. The polarity indicator system also should be

inspected for proper operation.

CORROSION ALLOWED TO BUILD ON THE ELECTRICAL CONNECTORS CAN CAUSE A

POOR CONNECTION RESULTING IN SHORTS, GROUND FAULTS OR POOR GROUND CON-

NECTIONS. ELECTRICAL CONNECTORS SHOULD CHECKED AT LEAST ANNUALLY AND

CLEANED AS REQUIRED. DO NOT ALLOW CORROSION TO BUILD ON CONNECTIONS.

THE AC AND DC ELECTRICAL SYSTEMS ALWAYS SHOULD BE DISCONNECTED FROM

THE POWER SOURCE BEFORE INSPECTING OR SERVICING THE SYSTEM. NEVER SER-

VICE ANY COMPONENT OF AN ELECTRICAL SYSTEM WHILE IT IS ENERGIZED.

4-10

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 139 140

No comments

PURSUIT 2870 OFFSHORE Owner's Manual Page 48