PURSUIT 3070 EXPRESS Owner's Manual download pdf (Page 61)

3070 EXPRESS

6.3 Livewell

Seawater is provided to the livewell by a 12-volt diaphragm pump. This pump is designed to

carry a constant flow of water to the livewell. The pump is activated by the baitwell switch in

the cockpit. An overflow built into the livewell automatically controls the water level in the

livewell. Always turn the pump off at the switch panel when the livewell is not in use.

The livewell pump is equipped with a sea strainer on the intake side of the pump located in the

bilge below the stern access hatches in the transom splashwell. This should be checked

frequently and cleaned as necessary.

To fill the livewell, insert the plug into the drain fitting at the bottom of the livewell. Make sure

the valve at the intake thru hull fitting is open and activate the baitwell switch. When the water

level reaches the overflow, it will begin to circulate.

To drain the livewell, turn off the livewell pump and pull out the plug in the drain fitting at the

bottom of the livewell. When the livewell has completely drained, use the washdown hose to

flush the livewell and drain of debris.

The livewell supply thru hull valve should be closed whenever the livewell is not in use. This

will prevent water from entering the livewell while the boat is cruising.

Note: Do not use the livewell as a dry storage area when it is not in use. Seawater could

accidently be delivered to the livewell from the thru hull fitting and damage

equipment stored there.

DO NOT RUN THE LIVEWELL PUMP DRY FOR EXTENDED PERIODS AS DAMAGE

TO THE PUMP WILL RESULT.

ALWAYS TURN THE LIVEWELL PUMP SWITCH TO THE “OFF” POSITION WHEN

LEAVING THE BOAT UNATTENDED.

6-3

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 168 169

No comments

PURSUIT 3070 EXPRESS Owner's Manual Page 61