PURSUIT OS 315 Owner's Manual download pdf (Page 22)

OS 315

The handles of dual lever controls may not always align with each other at all RPM settings due to variations

in control cable routing, cable length and adjustments at the engine. Usually the alignment of the handles can

be optimized at a chosen RPM, but may vary at other settings.

ALWAYS RETURN THE ENGINE THROTTLE LEVERS TO THE EXTREME LOW SPEED

POSITION BEFORE SHIFTING. NEVER SHIFT THE TRANSMISSION AT ANY THROTTLE

SETTING ABOVE IDLE RPM.

2.4 Neutral Safety Switch

Every control system has a neutral safety switch incorporated into it. This device prohibits the engine from

being started while the shift lever is in any position other than the neutral position. Control or cable adjustments

may be required to correct this condition should it persist. See your Pursuit dealer for necessary control and

cable adjustments.

The neutral safety switches should be tested periodically to ensure that they are operating properly. To test

the neutral safety switches, make sure the engines are tilted down and move the shift levers to the forward

position.

Make sure the control levers are not advanced past the idle position. Turn the ignition key to the

start position just long enough to briefly engage the starter for the engine.

Do not hold the key in the start

position long enough to start the engine. The starter should not engage for either engine. Repeat this test

with the shift levers in reverse and the engine throttles at idle. Again, the starter should not engage for either

engine. If the starter for either engine engages with the shift controls in any position other than the neutral

position, then the neutral safety switch is not functioning properly and you should contact your dealer and have

the neutral safety switch repaired before using your boat. If an engine starts in gear during this test,

immediately move the control levers to the neutral position and turn the engine off.

IN SOME SITUATIONS, IT MAY BE POSSIBLE TO ACCIDENTALLY START THE ENGINES

IN GEAR WITH THE THROTTLES ABOVE IDLE IF THE NEUTRAL SAFETY SWITCH IS

NOT OPERATING PROPERLY. THIS WOULD CAUSE THE BOAT TO ACCELERATE UN-

EXPECTEDLY IN FORWARD OR REVERSE AND COULD RESULT IN LOSS OF CONTROL,

DAMAGE TO THE BOAT, OR INJURY TO PASSENGERS. ALWAYS TEST THE NEUTRAL

SAFETY SWITCH PERIODICALLY AND CORRECT ANY PROBLEMS BEFORE USING THE

BOAT.

2.5 Engine Power Tilt and Trim

All outboard engines used on your boat have a tilt and trim feature. The tilt and trim switches are usually built

into the engine shift and throttle controls and allow the operator to control the position of the outboards from

the helm. Moving the outboards closer to the boat transom is called trimming “in” or “down.” Moving the

outboards further away from the boat transom is called trimming “out” or “up.” In most cases, the boat will

run best with the outboards adjusted so the hull will run at a 3 to 5 degree angle to the water.

The term “trim” generally refers to the adjustment of the outboards within the first 20

range of travel. This

is the range used while operating your boat on plane. The term “tilt” is generally used when referring to

adjusting the outboards further up for shallow water operation or trailering. For information on the proper

use and maintenance of the power tilt and trim, please refer to the engine owner’s manual.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 127 128

No comments

PURSUIT OS 315 Owner's Manual Page 22