PURSUIT 2470 WALKAROUND Owner's Manual download pdf (Page 94)

2470 WALKAROUND

CARBON MONOXIDE IS A LETHAL, TOXIC GAS THAT IS COLORLESS AND

ODORLESS. IT IS A DANGEROUS GAS THAT WILL CAUSE DEATH IN CERTAIN

LEVELS.

13.3 Cabin Interior

The cabin interior can be cleaned just like you would clean a home interior. To preserve the teak

woodwork, use teak oil. To maintain the carpeting, use a vacuum cleaner. Because air and

sunlight are very good cleansers, periodically put cushions, sleeping bags, etc. on deck, in the sun

and fresh air, to dry and air out. If cushions or equipment get wet with saltwater, remove and use

clean, fresh water to rinse off the salt crystals. Salt retains moisture and will cause damage. Dry

thoroughly and reinstall.

If mildew forms on the carpet-like headliner material, it can be cleaned with a solution of five parts

water to one part bleach. Remove all cushions, pillows and cabin sole carpet that could be

damaged by the bleach and make sure that all windows, hatches and doors are open while using

the bleach solution. Wear rubber gloves to protect your skin and follow all the precautions listed

on the bleach bottle label. Completely ventilate the cabin and allow the headliner to dry

thoroughly before using the cabin or closing the hatches and doors.

If you leave the boat for a long period of time, put all cushions on their sides, open all interior cabin

and locker doors, and hang a commercially available mildew protector in the cabin.

ALWAYS READ THE LABEL CAREFULLY ON MILDEW PROTECTORS. REMOVE

THE PROTECTOR AND ALLOW THE CABIN TO VENTILATE COMPLETELY BE-

FORE USING THE CABIN.

13.4 Bilge

Periodically check the bilge pumps for proper operation and clean debris from the strainers and

float switches. Inspect all hoses, clamps and thru hulls for leaks and tightness on a regular basis.

To keep the bilge clean and fresh, it is recommended that you use a commercial bilge cleaner on

a regular basis. Follow the directions carefully. All exposed pumps and metal components in the

bilge should be sprayed periodically with a protector to reduce the corrosive effects of the high

humidity always present in these areas.

Periodically check the bilge pumps for proper operation and clean debris from the strainers and

float switches. Inspect all hoses, clamps and thru hulls for leaks and tightness on a regular basis

and operate all thru hull valves at least once a month to keep them operating properly.

13-6

1 2 ... 89 90 91 92 93 94 95 96 97 98 99 ... 127 128

No comments

PURSUIT 2470 WALKAROUND Owner's Manual Page 94