PURSUIT 2470 WALKAROUND Owner's Manual download pdf (Page 49)

2470 WALKAROUND

6.3 Livewell

Sea water is provided to the livewell by a 12-volt

circulation pump. This pump is designed to carry a

constant flow of water to the livewell. The pump is

not equipped with a pressure sensor and is activated

by the livewell switch in the 12-volt panel or a

separate switch in the cockpit.

An overflow built into the livewell automatically

controls the water level in the livewell. Always turn

the pump “OFF” at the switch panel when the

livewell is not in use.

To fill the livewell, insert the plug into the drain fitting at the bottom of the livewell. Make sure

the valve at the intake thru hull fitting is open and activate the livewell switch. When the water

level reaches the overflow, it will begin to circulate.

To drain the livewell, turn off the livewell pump and pull out the plug in the drain fitting at the

bottom of the livewell. When the livewell has completely drained, use the washdown hose to flush

the livewell and drain of debris.

The livewell supply thru hull valve should be closed whenever the livewell is not in use. This will

prevent water from entering the livewell while the boat is cruising.

The livewell system is equipped with a sea strainer on the intake side of the pump located in the

bilge below the stern bench seat and fishbox. This should be checked frequently and cleaned as

necessary.

Note: Do not use the livewell as a dry storage area when it is not in use. Sea water could

accidently be delivered to the livewell from the thru hull and damage equipment

stored there.

6-3

Livewell

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 127 128

No comments

PURSUIT 2470 WALKAROUND Owner's Manual Page 49