PURSUIT OS 385 Owner's Manual Page 115

  • Download
  • Add to my manuals
  • Print
  • Page
    / 144
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 114
Troubleshooting Guide
E-3
Appendix E
OS 385
Problem Cause and Solution
The engine is loosing RPM. The boat is
not overloaded and the hull bottom and
running gear are clean and in good con-
dition.
The engine may be having a problem
with a sticky anti-siphon valve, located in
the fuel line near the fuel tank, that is
restricting the fuel flow. Remove & clean
or replace the anti-siphon valve.
The remote gasoline fuel filter could be
dirty. Inspect and replace the fuel filter.
The primary fuel filter on the engine may
be dirty. Inspect and replace the fuel fil-
ter.
The electronic engine control system on
the engine is malfunctioning. Repair the
engine control system.
The fuel injection system on the engine
is malfunctioning. Repair the fuel injec-
tion system.
Accessory Problems
The livewell pump runs, but does not
pump water.
The strainer on the intake scoop is
clogged preventing the water from get-
ting to the pump. Put the boat in reverse
to clean the strainer.
There is an air lock in the system. Run
the boat above 15 m.p.h. and the pick-up
scoop will force the air lock past the
pump and prime the system.
The thru-hull valve is not open. Open
valve.
The valve in the livewell is not open.
Open the valve in the livewell.
The automatic float switch on the bilge
pump raises but does not activate the
pump.
The in-line fuse near the battery switch
has blown. Replace the fuse.
The pump impeller is jammed by debris.
Clean pump impeller housing.
The pump is defective. Replace pump.
Page view 114
1 2 ... 110 111 112 113 114 115 116 117 118 119 120 ... 143 144

Comments to this Manuals

No comments