PURSUIT OS 315 Owner's Manual download pdf (Page 74)

10-4

Section 10 Operation

OS 315

Each person onboard must have at least

one personal flotation device onboard and

one throwable device. Check the U.S. Coast

Guard standards for the correct type

required for your boat.

• Make sure signal kits are onboard and

are in good operating condition and are

not expired.

• Make sure you have sufficient water and

other provisions for the planned cruise.

• Leave a written message listing details

of your planned cruise (Float Plan) with a

close friend ashore. Include a descrip-

tion of your boat, where you intend to

cruise, schedule of your arrival in the

cruising area and when you expect to

return. Keep the person informed of any

changes in your plan to prevent false

alarms. This information can tell authori-

ties where to look and your boat type in

the event you fail to arrive.

• Check the amount of fuel onboard.

Observe the “rule of thirds”: one third of

the fuel for the trip out, one third to return

and one third in reserve. An additional

15% may be consumed in rough seas.

• Check the water separating fuel filters for

water.

• Turn on the battery switches.

• Check for bilge water and for other signs

of potential problems. Monitor for the

scent of fuel fumes.

• Test the automatic and manual bilge

pump switches to make sure the system

is working properly.

• Have a tool kit and spare parts onboard.

The kit should include basic tools:

❑ Spark Plug Wrench

❑ Hammer

❑ Spark Plug Gap Gauge

❑ Electrician’s Tape

❑ Screwdrivers

❑ Lubricating Oil

❑ Pliers

❑ Jackknife

❑ Adjustable Wrench

❑ Vise Grip Pliers

❑ Needle Nose Pliers

❑ Wire Crimping Tool

❑ End Wrench Set

❑ Wire Connector Set

The spare parts kit should include:

❑ Extra Light Bulbs

❑ Spark Plugs

❑ Fuses and Circuit Breakers

❑ Flashlight and Batteries

❑ Drain Plugs

❑ Engine Oil

❑ Propellers

❑ Fuel Filters

❑ Propeller Nuts

❑ Fuel Hose and Clamps

• Make sure all fire extinguishers are in

position and in good operating condition.

• Make sure the shift control is in NEU-

TRAL.

• Make sure the emergency engine stop

lanyard is attached to the operator and

the stop switch.

10.5 Operating your Boat

The operator must be seated, and ready

with the controls (steering/throttle) when the

engine is started or running.

After Starting the Engines:

• Check engine gauges. Make sure all are

reading normally.

• Visibly check engines to be sure there

are no apparent water, fuel or oil leaks.

• Check operation of engine cooling sys-

tems.

• Check controls and steering for smooth

and proper operation.

• Allow engines to warm up for 10 to 15

minutes before operating them above

idle speeds.

• Make sure all lines, cables, anchors, etc.

for securing the boat are onboard and in

good condition. All lines should be

coiled, secured and off the decks when

underway.

• Have a safe cruise and enjoy yourself.

REMEMBER:

When operating a boat, you accept the

responsibility for the boat, safety of passen-

gers and others out enjoying the water.

1 2 ... 69 70 71 72 73 74 75 76 77 78 79 ... 111 112

Comments to this Manuals

No comments