PURSUIT 2670 Denali Owner's Manual Page 57

  • Download
  • Add to my manuals
  • Print
  • Page
    / 140
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 56
2670 Denali
57
Chapter 9:
EXTERIOR EQUIPMENT
9.1 Deck
Rails and Deck Hardware
The rail system and hardware fittings have been selected and installed to perform specific functions. Fenders
or mooring lines should be secured to the cleats and not to rails or stanchions. Mooring lines should be secured
to the cleats. Be sure a clear lead exists when running dock lines or anchor lines. A line inadvertently run
around a stanchion or over the rail could cause damage.
ALL FITTINGS MUST BE PERIODICALLY INSPECTED FOR LOOSE FIT OR WEAR AND
DAMAGE. ANY PROBLEMS SHOULD BE CORRECTED IMMEDIATELY.
PURSUIT BOATS ARE NOT EQUIPPED WITH HARDWARE DESIGNED FOR TOWING PUR-
POSES. THE MOORING CLEATS ARE NOT TO BE USED FOR TOWING ANOTHER VES-
SEL OR HAVING THIS BOAT TOWED.
Bow Pulpit and Roller
The bow pulpit is built into the hull and is equipped with a roller assembly that allows the anchor to be operated
and stored at the pulpit. The pulpit roller is designed for a Delta
®
plow or a Danforth
®
style anchor. The anchor
line is stored in the rope locker and routed out the rope locker hatch through the roller and connected to the
anchor chain. A chain binder is provided on the deck near the pulpit to secure the anchor. Always make
sure the anchor chain is secured by the chain binder before getting under way.
Anchor/Rope Locker
The anchor locker is in the bow of the boat and accessed through a hatch in the deck. The locker is recessed
for a Danforth
®
style anchor. The anchor line is always stored in the locker. If an anchor is stored in the anchor
locker, it must be properly secured to prevent it from bouncing in the locker and causing damage to the hull
or anchor locker.
The anchor locker is drained by a thru-hull fitting in the hull side near the bottom of the locker. It is very
important to check the drain frequently to make sure it is clean and free flowing.
THE ANCHOR MUST BE POSITIONED SO IT DOES NOT REST AGAINST THE HULL
SIDES AND BE PROPERLY SECURED AT ALL TIMES WHEN IT IS STORED IN THE AN-
CHOR LOCKER. A LOOSE ANCHOR IN THE ANCHOR LOCKER WILL BOUNCE AND
CAN DAMAGE THE BOAT. DAMAGE RESULTING FROM THE ANCHOR BOUNCING IN
THE ANCHOR LOCKER IS NOT COVERED BY THE PURSUIT WARRANTY.
Page view 56
1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 139 140

Comments to this Manuals

No comments